Meaning
Formation of wavy, non-uniform edges around the top rim of a deep-drawn metal cup represents a plastic deformation defect caused by directional variations in sheet properties. This earing results in material waste because the irregular tops of the cups must be trimmed off to produce a straight finished edge. Packaging and automotive manufacturers monitor this behaviour to minimise trim scrap in high-speed pressing operations.
Planar Anisotropy
Variation of the plastic strain ratio in the plane of the sheet dictates where the peaks and valleys will form during drawing. If the strain ratio is higher at forty-five degrees to the rolling direction than at zero and ninety degrees, the metal flows more easily at those angles, creating distinct peaks. Preferred crystallographic orientation, established during hot and cold rolling, causes these directional properties.
Eliminating this texture is a primary goal of subsequent recrystallisation annealing cycles in metal production.
Anisotropy Parameter
Calculated values of the planar anisotropy coefficient indicate the height and location of the generated waves. When the coefficient is zero, no waves form and the cup edge remains flat. Positive values lead to peaks at zero and ninety degrees, while negative values produce them at forty-five degrees.
Metallurgists measure this coefficient using multi-directional tensile tests to predict stamping line scrap rates.
Stamping Limit
Trim presses are integrated into the production line to slice away the uneven upper boundary of each drawn part. This step adds processing time and tool wear to the assembly operation. Reducing wave height lower than three percent of the cup height is a standard target for aluminum can-stock suppliers.