Meaning
Permanent transverse expansion of a solid ductile body occurs when compressive axial loading exceeds the compressive yield strength of the material. In mechanical assembly and terminal processing, plastic upsetting produces intentional cross-sectional enlargement while shortening original length, forcing the material into tight mechanical contact or predetermined geometry within a die. The process measures dimensional deformation and strain hardening across a specified axial force limit.
It ceases to apply once the compressive load falls back into the elastic deformation regime, or when axial stresses generate shear failure, cracking, or material rupture along outward grain boundaries.
Deformation Dynamic
Compressive mechanical forces overcome the yield point of the metal, activating extensive dislocation movement along atomic slip planes. During plastic upsetting, the metallic column shortens axially while expanding radially to maintain constant physical volume throughout the plastic phase. The material flows outward until it meets the constraint of an exterior collar, die wall, or mating hole, establishing intimate surface conformity.
Friction generated between the tool face and the workpiece creates lateral surface shear, producing a characteristic barreling shape if unconstrained by an exterior die. Work hardening accumulates rapidly across the deformed zone, raising both the hardness and the yield strength of the expanded section above baseline material values.
Terminal Manufacturing
Construction of structural electrical connections across energy storage components relies upon controlled material deformation to create high-amperage joints. In solid busbar riveting and terminal pin retention, plastic upsetting expands rivet shanks, terminal studs, and copper posts inside mating module holes. The process eliminates microscopic clearance gaps between current-carrying busbars and cell terminals, producing low electrical resistance and high mechanical pull-out strength without the thermal penalty of fusion welding.
Radial expansion applies continuous residual contact pressure against the surrounding conductor walls, preventing loose mechanical play across thousands of operating vibration cycles.
Process Limitation
Successful execution of the deformation depends directly on material ductility, compressive force control, and component geometry. When executing plastic upsetting, copper or aluminum conductors require sufficient elongation capacity to endure severe strain without developing micro-cracks along their perimeter. If the ratio of unsupported length to diameter exceeds critical buckling limits, typically three to one, the workpiece buckles sideways rather than upsetting uniformly.
Insufficient axial force fails to drive material past its yield threshold, resulting in elastic recovery that loosens the electrical connection, while excessive force drives grain boundary separation or shears adjacent battery terminal seals.