Meaning
Manganese-alloyed wrought aluminium sheet strain-hardened to a half-hard temper defines a standard metallic casing material used for deep-drawn prismatic battery cans and module enclosures. Within cell manufacturing, aa3003-h14 provides a tensile strength between 140 and 180 megapascals, balancing deep-draw formability against burst-pressure resistance. The specification governs chemical composition under international alloy registries and strain-hardening limits that prevent wall thinning during progressive stamping.
Its definition stops at the unformed wrought sheet or strip state, excluding final can dimensional tolerances, post-forming burst ratings and surface chemical treatments applied by cell assemblers.
Forming Behavior
Cold working during high-speed transfer press operations alters the temper profile across drawn can bodies. Raw aa3003-h14 exhibits uniform elongation around eight to twelve percent, allowing ironing into thin sidewalls without localized necking. Plastic strain concentrates at the bottom corner radii, elevating local hardness while thinning the material.
Excessive initial temper hardness causes flange tearing during cupping, whereas softer tempers cause sidewall buckling under punch loads.
Laser Weldability
Hermetic enclosure sealing requires controlled melt pool dynamics during cap-to-can joining. The manganese content of aa3003-h14 suppresses hot cracking compared to copper-rich or magnesium-rich wrought alloys, supporting continuous seam welds using infrared or green laser sources. Surface oxide layers introduce micro-porosity if chemical degreasing and mechanical cleaning fail prior to welding.
Porosity reduces enclosure fatigue life under cyclic internal pressure generated during formation cycles.
Burst Resistance
Structural compliance requires cell casings to maintain hermetic integrity up to specified safety valve activation thresholds. Cans stamped from aa3003-h14 must resist sidewall deflection that alters internal electrode pressure while yielding predictably at the scored vent membrane. Sourcing contracts specify minimum burst pressures above 1.2 megapascals for automotive prismatic form factors.
Deviation in coil gauge thickness directly alters vent rupture thresholds. Proper temper verification ensures the cell ruptures along the designated score line prior to seam failure.