Meaning
Mechanical characterization of structural alloys relies on measuring the reduction in fatigue life caused by the presence of a surface geometric discontinuity. In engineering design, fatigue notch sensitivity quantifies how severely a specific material is affected by scratches, holes, or sharp corners under cyclic loading. When cyclic loads are applied, the local stresses around these discontinuities increase and accelerate crack initiation.
A low value indicates that the material resists crack propagation despite surface imperfections.
Stress Concentration
Calculation of the notch factor involves comparing the fatigue limit of an unnotched specimen to that of a specimen with a defined geometric interruption. The index for fatigue notch sensitivity ranges from zero to one. A value of zero represents a material completely insensitive to notches, while a value of one indicates full sensitivity where the theoretical stress concentration is fully realized.
Materials Evaluation
High-strength alloys and hardened steels often exhibit elevated sensitivity to surface defects because their limited plastic zone size at the crack tip prevents local stress redistribution. In contrast, softer alloys can deform plastically to relieve the local stress concentration. Materials selection for rotating shafts requires careful evaluation of fatigue notch sensitivity to ensure that machining marks do not cause sudden, catastrophic failures.
Designers must balance tensile strength against this sensitivity to optimize component life. Failure to account for this behavior leads to unexpected fractures in service.
Design Tolerance
Manufacturing processes determine the surface finish and the severity of mechanical notches introduced during machining. Adjusting the geometry of fillets and radiused corners represents a primary method to mitigate the detrimental effects of fatigue notch sensitivity. Components with generous transition radii experience lower localized stress.