Meaning
Microscopic gas pockets trapped within structural adhesives, thermal interface pastes, or solder joints reduce effective contact area across bonded interfaces. During battery pack assembly, micro voiding introduces localized thermal resistance hot spots and mechanical stress concentrations. The defect category applies to liquid-dispensed resins and soldered electrical connections, terminating where macroscopic voiding caused by mechanical entrapment predominates.
Defect Formation
Solvent evaporation and outgassing during curing create tiny internal gas bubbles inside thermosetting polymers. Fast mixing or high-pressure dispensing drives air entrapment, encouraging micro voiding throughout the joint volume. Moisture absorption in un-cured resin batches further exacerbates volatile gas evolution.
Thermal Consequence
Trapped gas voids act as thermal insulators, obstructing conductive heat flow from battery cells to cooling plates. Interfacial micro voiding elevates local thermal impedance, driving localized temperature spikes that accelerate cell degradation. Concentrated mechanical stresses around void boundaries promote adhesive bond line failure under thermal shock cycles.
Increased structural fatigue decreases adhesive joint longevity in rugged operating environments.
Quality Control
Non-destructive ultrasonic inspection and X-ray imaging detect internal void distribution within bonded battery assemblies. Quality standards cap total void area at less than five percent of the overall joint surface. Dispensing process optimization minimizes void formation during automated manufacturing.